Mostrar código-fonte de Instalando o driver B3C-LC

Step to perform the first installation of B3C-LC driver on a Windows System.<br />

== Verification of of communication ==
Using a serial port terminal (example [http://www.putty.org/ putty.exe]) it is possible to verify if the controller is communicating.<br />
The port connected shall be identified by the user.<br />
The communication speed is set to a baud rate of 9600.<br />
In the terminal windows type:
* CTRL+ECB: If the controller reply "ready" the communication is set.
* VERSION: the controller reply with the firmware version.
<br />

Once established the communication the software can be installed.<br />


== Installing the software ==
The software shall be installed and registered in windows.<br />
The driver is the file called <code>Leitzprotocoll.dll</code> located in the <code>..\Windows\SysWOW64</code>.<br />


Steps to register:
* run <code>CMD.EXE</code> from windows, be sure it is run  <code>As Administrator</code>
* type the command: <code>c:\Windows\Microsoft.NET\Framework\v2.0.50727\regasm /u c:\windows\syswow64\Leitzprotocoll.dll</code>
* type the command: <code>c:\Windows\Microsoft.NET\Framework\v2.0.50727\regasm /codebase c:\windows\syswow64\Leitzprotocoll.dll</code>


After those steps the file is registered and the controller can be connected to ARCO using the configuration in the control panel.


[[it:Installazione del driver B3C-LC]]
[[zh-cn:安装B3C-LC驱动程序]]
[[pt:Instalando o driver B3C-LC]]
[[de:Installation des B3C-LC-Treibers]]
[[es:Instalación del controlador B3C-LC]]
[[en:Installing B3C-LC Driver]]